Compatible-systems MicroRouter 2220R Uživatelský manuál stáhnout pdf (Strana 29)

Chapter 6 - Basic Configuration Guide 23

PPP Configuration

This section covers the settings required for PPP (point-to-point)

protocol operation of the WAN interfaces.

Link Configuration

Required for Dedicated/Leased Line Operation

Dedicated line operation is the simplest to set up.

• Set Dedicated connection

• Set PPP connection

CV: Use the Link Configuration: WAN 1 Dialog Box.

TB: Use configure and set the Mode and ConnectMode keywords in

the Link Config WAN 0 (and/or WAN 1) section.

Suggested for Dedicated/Leased Line Operation

Dedicated line operation generally does not require additional parame-

ters for operation.

Required for Dial-On-Demand Operation

Incoming dial-on-demand operation requires only slightly more infor-

mation than dedicated line setup. Outgoing dial-on-demand requires

additional information (see the suggested settings below).

• Set dial-up connection

• Set PPP connection

• Set to allow dial-in and/or dial-out

CV: Use the Link Configuration: WAN Dialog Box.

TB: Use configure and set the Mode, ConnectMode, DialIn and/or

DialOut keywords in the Link Config WAN 0 (and/or WAN 1)

section.

Suggested for Dial-On-Demand Operation

This mode of operation is only supported on the WAN 1 RS-232 inter-

face. Outgoing dial-on-demand requires some additional information.

• Create dial-out script

• Set dialing method

• Set dial-out script to be used

• Set inactivity time

CV: Use the Link Configuration: WAN 1 Dialog Box to set the dialing

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 48 49

Žádné komentáře

Compatible-systems MicroRouter 2220R Uživatelský manuál Strana 29