Compatible-systems MicroRouter 900i Uživatelský manuál stáhnout pdf (Strana 15)

Chapter 3 - Network Installation 9

Chapter 3 - Network Installation

900i MicroRouter Back Panel

This section of the manual describes how to connect the MicroRouter

900i to your Ethernet network and your wide area communications

device. In summary, the steps for installation are:

1. Make sure the router is powered down and not plugged to any

power source.

2. Wall mount the router, if required.

3. Connect the router to the Ethernet network.

4. Connect the router to the wide area line communications device.

5. Power up the line communications device.

v Note: You should either wait to connect a synchronous line device

such as a CSU/DSU until after the interface has been configured as a

synchronous port, or power up the router before powering up the

CSU/DSU. (See Chapter 6 - Basic Configuration Guide for more infor-

mation on configuring the router.)

6. Plug in the power supply and power up the router.

Mounting the Router

The MicroRouter 900i can be left standalone on a desktop or equipment

table, or can be wall mounted.

v Note: Wall mounting requires a wall-mount bracket kit (part number

A00-0987) from Compatible Systems.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Žádné komentáře

Compatible-systems MicroRouter 900i Uživatelský manuál Strana 15