Compatible Systems MicroRouter 2270R Uživatelský manuál stáhnout pdf (Strana 29)

Chapter 6 - Basic Configuration Guide 23

PPP Configuration

This section covers the settings required for PPP (point-to-point)

protocol operation of the WAN interfaces.

Internal T1 CSU/DSU (WAN 0) Link Configuration

Required for Dedicated Line Operation

This is the only mode of operation supported via the built-in T1

CSU/DSU.

• Set PPP connection

CV: Use the Link Configuration: WAN 0 Dialog Box.

TB: Use configure and set the Mode keyword in the Link Config

WAN 0 section.

Suggested for Dedicated/Leased Line Operation

Dedicated line operation generally does not require additional parame-

ters for operation.

RS-232 (WAN 1) Link Configuration

Required for Dedicated/Leased Line Operation

Dedicated line operation is the simplest to set up.

• Set Dedicated connection

• Set PPP connection

CV: Use the Link Configuration: WAN 1 Dialog Box.

TB: Use configure and set the Mode and ConnectMode keywords in

the Link Config WAN 1 section.

Suggested for Dedicated/Leased Line Operation

Dedicated line operation generally does not require additional parame-

ters for operation.

Required for Dial-On-Demand Operation

This mode of operation is only supported on the WAN 1 RS-232 inter-

face. Incoming dial-on-demand operation requires only slightly more

information than dedicated line setup. Outgoing dial-on-demand

requires additional information (see the suggested settings below).

• Set dial-up connection

• Set PPP connection

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 48 49

Žádné komentáře

Compatible Systems MicroRouter 2270R Uživatelský manuál Strana 29