Compatible Systems MicroRouter 900i Uživatelský manuál stáhnout pdf (Strana 40)

40 - Work Holding - Section 6 Microrouter CNC Machine User's Manual

6: The Work Holding Clamp Rail Components

The easiest method of holding large, flat workpieces in the working

area of the Microrouter is using a series of work holding clamp rails.

Each clamp fits between the front and rear X axis sliderail frames

and grips the workpiece in a similar way to a G-clamp or vice.

Additional clamps can be fitted between the X axis sliderails to give

support to longer or thinner workpieces.

iii

Each clamp rail is constructed from:

i) One long, deep, U shaped extruded

metal section. Each end of this

section contains two threaded holes

on the flat surface of the channel,

together with two slots cut into the

channel sides.

ii) One short, shallow, U shaped

extruded metal section. Each end of

this section contains one hole on the

flat surface of the channel.

iii) Two fully threaded M8 allen headed

bolts approx. 30mm in length.

iv) Two part threaded M8 allen headed

bolts approx. 60mm in length.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 93 94

Žádné komentáře

Compatible Systems MicroRouter 900i Uživatelský manuál Strana 40