Compatible Systems MicroRouter 900i Uživatelský manuál stáhnout pdf (Strana 43)

Section 6 - Work Holding - 43Microrouter CNC Machine User's Manual

Turn 5mm

allen key

clockwise to

tighten bolt.

6: Using the Work Holding Clamp Rails

To clamp the workpiece:

1) Adjust the spacing between the

upper and lower clamp rails, if

necessary, so sufficient areas

of the workpiece can be

securely clamped. To increase

the “gap” between the upper

and lower clamp rails, loosen

each of the two innermost allen

bolts (turning anticlockwise,

when viewed from above).

Always use at least 2

clamp rails to clamp the

workpiece.

Additional clamps

should be used to

support longer or

thinner workpieces

(ensure these clamps

are positioned in areas

where no machining will

occur).

Note

2) Position the workpiece under the top U shaped sections of each

clamp rail. Using a 5mm allen key, tighten the innermost allen

bolts (turning clockwise, when viewed from above) to lock the top

U shaped sections onto the workpiece. Check that the workpiece

is secure before commencing any machining operations.

X axis

sliderail

frame.

Top U shaped

section of

clamp rail.

Bottom U

shaped section

of clamp rail.

Innermost allen

bolt locks top U

shaped section

over workpiece.

Workpiece.

The two

innermost

allen bolts

define what

thickness of

material can

be clamped.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 93 94

Komentáře k této Příručce

Žádné komentáře

Compatible Systems MicroRouter 900i Uživatelský manuál Strana 43

Komentáře k této Příručce

Související produkty a manuály pro Sítě Compatible Systems MicroRouter 900i