Compatible Systems MicroRouter 900i Uživatelský manuál stáhnout pdf (Strana 68)

68 - Technical Support - Section 9 Microrouter CNC Machine User's Manual

9: Troubleshooting

VR CNC Milling Software Communications Troubleshooting

continued...

5) In the “Machine Properties” window, click the “Communications”

property title. Change the “COM Port” setting to match the

number of the COM port being used by your pc. Note that the

hardware resources ( IRQ. etc.) are those specified in the

Windows Control Panel. The “Baudrate” must be set to read

“19200”. Baudrate is the speed at which data can be transferred

through your COM ports. The “Stop Bits” must be set to read “2”.

Stop Bits are the data signals sent after each data character has

been transferred. Click the [OK] button to save and apply any

changes made to the property listings.

6) Check the LED display status on your Microrouter control card

(The Denstep Motion Control Board). The control card is the

main electrical board in the Microrouter, located in the top left

corner of the electrical panel. For more information, refer to

Section 8 - Machine Electronics. A problem with this card can

cause problems with communications. Look for the LED display

mounted on the main control card. A blinking dot with an L or the

number 8 should be shown. If the LED is not lit, check the

control board fuse. If no display continues to be shown, call

Denford Customer Services for assistance.

7) Check the COM port on your pc is functioning correctly. Consult

your IT person or Computer Support Centre for help with these

issues. Check the COM port settings in Windows by accessing

the Device Manager. Check the com ports enabled and labelled

properly in the computer BIOS. Check the physical COM port

itself functional. For example, Windows and the BIOS may show

that the COM ports are fine, but the port is not seen by any

external devices.

8) When all else fails....

a) Thoroughly check the condition of the RS232 cable. If the

cable is bad, communication will not occur.

b) Try using a different pc to connect to the CNC machine.

c) Check for support on the Denford website (www.denford.com).

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 93 94

Žádné komentáře

Compatible Systems MicroRouter 900i Uživatelský manuál Strana 68